Snake Plant Care Guide
Published On: Aug 23, 2019
Share:
If you have ever been told you have a "black thumb," the snake plant is your redemption. It shrugs off low light, skipped waterings, and dry winter air, and it looks sharp doing it, with stiff, upright leaves striped in green, silver, and gold.
Here is the catch: the one thing that kills snake plants is too much love. More snake plants die from overwatering than from everything else combined.
The good news? Once you learn to leave it alone, a snake plant will grow happily for years and even make new plants for you. This guide covers light, watering, soil, feeding, repotting, and propagating snake plants, plus how to fix the few problems they run into.
What Is a Snake Plant?
Snake plants, also called mother-in-law's tongue, are native to dry regions of West Africa. Botanists recently moved them from Sansevieria to Dracaena trifasciata, but most people still call them sansevieria.
We grow a few favorites:
- Laurentii Snake Plant: tall green leaves with gray-green bands and bright golden-yellow edges.
- Black Coral Snake Plant: dark green leaves with silvery banding, about three feet tall.
- Black Gold Snake Plant: very dark green leaves with narrow gold edges.
How Much Light Does a Snake Plant Need?
Snake plants are famous for tolerating low light, which makes them a good choice for bedrooms, offices, and hallways. They even grow under fluorescent light.
Tolerating is not the same as thriving, though. A snake plant grows fastest and keeps its strongest color in bright, indirect light, like a spot a few feet from a sunny window. In very low light it barely grows, and you need to water it even less.
A few hours of direct sun is fine once a plant is used to it. If you move one outside for the summer, start it in shade and work up to more light gradually, or the leaves will scorch.
How Often Should You Water a Snake Plant?
Less than you think. Let the soil dry out completely before watering again.
- Spring and summer: about every two to three weeks, depending on light and warmth.
- Fall and winter: about once a month, or even less.
When you do water, soak the soil until water runs out the drainage hole, then empty the saucer. Never let a snake plant sit in water. Water the soil, not into the center of the leaves, where water can collect and rot the base.
Not sure? Push a finger two inches into the soil. If it is at all damp, wait.
What Soil and Pot Does a Snake Plant Need?
Use a fast-draining mix such as Espoma Organic Cactus Mix. Regular potting soil holds too much water.
Always use a pot with a drainage hole. Terra cotta is ideal because it breathes and helps the soil dry out between waterings. Plant at the same depth the snake plant grew in its nursery pot. Burying the base of the leaves invites rot.
Should You Fertilize a Snake Plant?
Lightly. Feed once a month in spring and summer with a balanced houseplant fertilizer such as Jack's Classic Houseplant Special Fertilizer mixed at half strength. Or, for the easiest option, mix a slow-release fertilizer such as Osmocote Plus Outdoor and Indoor Plant Food into the top of the soil once in spring. Do not feed in fall and winter, when the plant is resting.
What Temperature Do Snake Plants Like?
Normal room temperatures between 60 and 85 degrees are perfect. Snake plants are damaged below about 50 degrees, so keep them away from cold, drafty windows and doors in winter.
If your snake plant spends summer on a patio, bring it back inside once nighttime temperatures drop below 55 degrees. In frost-free areas like South Florida, snake plants grow outdoors year-round.
Average household humidity is fine. Snake plants do not need misting.
When Should You Repot a Snake Plant?
Snake plants like a snug pot and only need repotting every two to three years, or when roots start pushing out of the drainage hole or the pot begins to bulge or crack. Repot in spring or summer.
Move up only one or two inches in pot size. A pot that is too big holds extra soil that stays wet and causes rot.
How Do You Propagate a Snake Plant?
Snake plants send up new shoots, called pups, from underground runners, so they are easy to multiply.
Division
The fastest way. When repotting, separate a pup from the mother plant with a clean, sharp knife, keeping some roots attached, and pot it up on its own in cactus mix. Wait about a week before watering so the cut can heal.
Leaf Cuttings
Cut a healthy leaf into three-inch sections, keeping track of which end was the bottom. Let the cuts dry for a day or two, then set the sections bottom-end down about an inch deep in moist cactus mix. Keep them barely damp. Roots and new shoots appear in a few weeks to a couple of months.
One catch: leaf cuttings from Laurentii lose their golden edges and grow back plain green. To keep the gold stripe, propagate Laurentii by division.
Common Snake Plant Problems
Soft, Mushy Leaves or Base
Root rot from overwatering, the number one snake plant problem. Unpot the plant, cut away any soft, brown roots and leaves, let it dry for a day, and repot in fresh, dry cactus mix. Then water much less often.
Wrinkled or Curling Leaves
Usually thirst, if the soil has been bone dry for a long time. Give it a thorough soak. If the soil is wet and the leaves are still wrinkling, the roots have rotted. Check them.
Leaves Falling Over
Overwatering, too little light, or a top-heavy plant in a small pot. Check the roots first, then move it to brighter light.
Brown Tips or Spots
Brown tips usually come from inconsistent watering. Tan, papery patches can be sunburn from a sudden move into direct sun, or cold damage from a drafty window.
Pests
Snake plants rarely have pests. Occasionally mealybugs show up as white cottony spots at the base of the leaves. Wipe them off with a cotton swab dipped in rubbing alcohol.
Do Snake Plants Clean the Air?
A well-known NASA study found that snake plants could remove some indoor air pollutants in small sealed test chambers. In a real home, you would need a room full of plants to make a measurable difference, so think of snake plants as a beautiful, easy houseplant rather than an air purifier.
One fun fact that does hold up: snake plants open their pores at night to save water, so they take in carbon dioxide after dark, unlike most houseplants.
Are Snake Plants Toxic to Pets?
Yes, mildly. Snake plants contain saponins that can cause drooling, vomiting, or diarrhea in cats and dogs if chewed. Keep them out of reach of pets that like to nibble.
Shop the Snake Plant Collection
Woodie's Take
I tell everyone the same thing about snake plants: pick a pot with a drainage hole, fill it with cactus mix, and then try to forget about it. When you remember it, check the soil. If it is dry all the way down, water. If not, walk away.
That is honestly the whole secret. Treat it like a desert plant, and it will outlive most of the other plants in your house.
Frequently Asked Questions About Snake Plants
How often should I water my snake plant?
Only when the soil is completely dry: about every two to three weeks in spring and summer, and about once a month or less in winter.
Can snake plants live in low light?
Yes. Snake plants tolerate low light better than almost any houseplant, though they grow faster and stay more colorful in bright, indirect light.
Why is my snake plant turning mushy?
Mushy leaves or a soft base mean root rot from too much water. Cut away the rotted parts, repot in dry cactus mix, and water less often.
How big do snake plants get?
Most of the varieties we grow reach about two to four feet tall indoors, growing slowly over several years.
How do I make my snake plant grow faster?
Give it brighter, indirect light, warmth, and a light monthly feeding in spring and summer. Snake plants are naturally slow growers, especially in low light.
Are snake plants safe for cats and dogs?
No. Snake plants are mildly toxic to pets and can cause vomiting or diarrhea if eaten.
Do snake plants flower?
Occasionally. Mature, slightly root-bound plants sometimes send up a stalk of small, fragrant white flowers, usually in spring.
Should I cut brown tips off my snake plant?
You can trim brown tips with clean scissors, following the natural shape of the leaf. The cut edge will not regrow, so trim just inside the brown.